Frequently Asked Questions of Anet ET4 / ET5 Series 3D Printer

  • December 31, 2020 Anet 3D

    Multimeter Measurement Guidance for Anet 3D Printer

    Sometimes we just need a multimeter to measure out the precise values of voltages or resistances on some electronic components of Anet 3D printer. These values will help us find out the real reasons why the printer doesn’t work well....

    Read now
  • Day One Set up Bed and Sensor
    November 13, 2020 Anet 3D

    Day One Set up Bed and Sensor

    Home Nozzle Z height - Set the Sensor. Go to PREPARE > PreHeat >tap the hot bed icon > tap + to increase heat to 60.Change menu page.Where ever your X carriage and nozzle is located now.Leave it where it...

    Read now
  • October 8, 2020 Anet 3D

    Set print height of the Anet ET4. Firmware V 1.1.2

    Credit to: Hans de Bruijn Switch off the machine.Adjust the print-bed.Lower the nozzle manually and adjust the height between the nozzle and print-bed.It is important that the space between nozzle and print-bed is the same at all corners about the...

    Read now