ET Series

RSS
  • Day One Set up Bed and Sensor
    November 13, 2020 Anet 3D

    Day One Set up Bed and Sensor

    Home Nozzle Z height - Set the Sensor. Go to PREPARE > PreHeat >tap the hot bed icon > tap + to increase heat to 60.Change menu page.Where ever your X carriage and nozzle is located now.Leave it where it...

    Read now
  • How to Avoid Layer Shift in 3D Printing
    October 24, 2020 Anet 3D

    How to Avoid Layer Shift in 3D Printing

    Recently, someone asked us a question about how to avoid layer shifting.     It is the question we got from our user, it is like a same old question, we have seen many different reasons that contribute to layer shifting....

    Read now
  • October 8, 2020 Anet 3D

    Set print height of the Anet ET4. Firmware V 1.1.2

    Credit to: Hans de Bruijn Switch off the machine.Adjust the print-bed.Lower the nozzle manually and adjust the height between the nozzle and print-bed.It is important that the space between nozzle and print-bed is the same at all corners about the...

    Read now
  • March 11, 2020 Cathy He

    Troubleshootings FAQ on ET4 and others

    Today, we collected five main difficulties that users have with ET4. Luckily, they are all not big problems. Only a little fine-tune and checkout can just figure them out. For some issues, we have independently released their approaches before, so...

    Read now