ET4 Configuration on Cura
Hello guys, this guildline is for those who met with troubles when Anet ET4 printer cannot perfectly print out the file edited on Cura. Here we introduce “auto” and “manual” two methods to configure the best Cura setting for ET4!
Let's get started!
*UPDATE
The Ultimaker Cura 4.7.1 setting for Anet ET4, ET4X and ET4 Pro 3D printers is available on the following link.
Settings in Ultimaker Cura 4.7.1 for Anet ET4 Series 3D Printers
The Ultimaker Cura 4.7.1 setting for Anet ET5, ET5X and ET5 Pro 3D printers is available on the following link.
File Setup in Ultimaker Cura 4.7.1 for an Anet ET5 3D Printer
- Cura profile of Anet ET4 for auto load:
I. Here We provide configuration files for Mac and Windows
ET4 Configuration on Cura for Mac
ET4 Configuration on Cura for Windows
II.Now import them into Cura!
2.1.On Ultimaker Cura(matching ".curaprofile" files):
Open “Preferences--->Profiles--->Import--->ET-4 Cura Ultimaker.curaprofile (ET4-Mac.curaprofile for Mac user)”
2.2 On Cura DGO 14.07(matching ".ini" files):
Open “File--->Open Configuration--->ET4 CURA 14.07.ini”
-
Cura profile of Anet ET4 for manual settings:
(Refer to or download the pictures below to acoordingly set each item of parameter.)
I. On Ultimaker Cura
II. On Cura DGO 14.07
2.1 Select “File--->Machine Setting--->Add new machine---> Prusa Mendel i3”
2.2 According to the pictures below, set each item of parameter.
All steps are put above. Welcome to contact us if you have any problems. Hope you all can have a good printing experience on ET4! See you next time.
Comments
Leave a comment