Frequently Asked Questions of Anet ET4 / ET5 Series 3D Printer

  • Day One Set up Bed and Sensor
    November 13, 2020 Anet 3D

    Day One Set up Bed and Sensor

    Home Nozzle Z height - Set the Sensor. Go to PREPARE > PreHeat >tap the hot bed icon > tap + to increase heat to 60.Change menu page.Where ever your X carriage and nozzle is located now.Leave it where it...

    Read now
  • October 24, 2020 Anet 3D

    How to Avoid Layer Shift in 3D Printing

    Recently, someone asked us a question about how to avoid layer shifting. There are many different reasons that could contribute to layer shifting. So it’s hard to pinpoint it to just one. The most common we seen from many cases are the...

    Read now
  • October 8, 2020 Anet 3D

    Set print height of the Anet ET4. Firmware V 1.1.2

    Credit to: Hans de Bruijn Switch off the machine.Adjust the print-bed.Lower the nozzle manually and adjust the height between the nozzle and print-bed.It is important that the space between nozzle and print-bed is the same at all corners about the...

    Read now
  • March 11, 2020 Cathy He

    Troubleshootings FAQ on ET4 and others

    Today, we collected five main difficulties that users have with ET4. Luckily, they are all not big problems. Only a little fine-tune and checkout can just figure them out. For some issues, we have independently released their approaches before, so...

    Read now